TagsBooks chloride ChRs Cryptochrome Dimerizers Electroporation Epilepsy Expression fiberoptics FRET GECI GEVI Highlighters Holography hVoS Indicators LED Lines LOV Opsins Optics Optrodes Phototropin prosthetics protons Pumps Recordings Reporter Retina Reviews Scattering Therapeutics Thoughts Toxicity Viruses Voltage waveguides
Category Archives: Journal Club
Long-term channelrhodopsin-2 expression can induce abnormal axonal morphology and targeting in cerebral cortex
When using optogenetics to study circuit function or animal behavior, a critical prerequisite is that optogenetic protein expression does not, in itself, perturb the circuit being studied. While short-term expression is very commonly used without observable circuit disruption, whether this is also true for long-term expression is less clear. A recent paper by Miyashita et al. in Frontiers in Neural Circuits shows that long-term, high-level expression of ChR2 can induce abnormal axonal morphology and targeting in cerebral cortex. This underscores the importance of using the lowest expression possible, particularly for long-term studies.
Miyashita et al. expressed a common construct, CAG::hChR2 (H134R)-EYFP-WPRE, in L2/3 pyramidal neurons in rat somatosensory cortex via in utero electroporation (IUE). This same strategy was used in several prior studies of S1 circuit function, with one important difference: Miyashita et al. expressed hChR2 that was codon-optimized for mammalian expression, while prior studies expressed native ChR2 (discussed below). This strategy successfully conferred light-evoked spiking in vivo and in in vitro brain slices. However, long-term expression (> 40 d) also caused major abnormalities in axonal morphology, which included cylinders of axonal membrane that enveloped pyramidal cell proximal dendrites, and spherical, calyx-like axonal swellings that surrounded neuron cell bodies. These … Continue reading
The optopatcher: an electrode holder allowing the insertion of an optical fiber into a patch pipette
In order to perform simultaneous intracellular recording and light stimulation of a single neuron, two separate positioning systems are often needed (one to position the recording electrode, one to position a waveguide near the recorded neuron). More sophisticated solutions for single neuron photostimulation involve light patterning techniques which are not suited for deep in vivo recordings. Katz et al. came up with a simple and affordable solution for this problem, by designing a patch pipette holder containing an additional port for the insertion of an optical fiber into the pipette.
This device, which they called “OptoPatcher” allows whole cell patch-clamp recording simultaneously with direct projection of light from the recording pipette. The holder spares the use of an additional manipulator and, importantly, enables accurate, stable and reproducible illumination. Moreover, the presence of the bare fiber within an aqueous solution instead of the brain can prevent tissue damage due to heating of the brain. In addition, replacement of standard pipettes is done as easily as with the available commercial holders.
The OptoPatcher was used successfully in vivo for intracellular recordings from different cortical layers in the motor cortex of transgenic mice expressing channelrhodopsin-2 under the Thy1 promoter and it was also … Continue reading
Wen Li’s group at Michigan State University recently presented preliminary results on the development of an epidural micro-electrocorticogram (μECoG) array combining microelectrodes and light emitting diodes (LEDs) for optical neural stimulation. This work follows-up on a new line of research aiming at providing μECoG arrays with versatile optical stimulation capabilities (see for example the work of Ledochowitsch et al). The “Opto-μECoG” arrays developped in Wen Li’s group were especially designed to address three major limitations of current designs, in particular the limited cortical area and spatial resolution available for optical stimulation. The key features of these Opto-μECoG arrays are the following:
Untethered system: integration of surface mounted μ-LED light sources (220 × 270 ×50 μm3, wavelength peak at 460nm, Cree® TR2227TM) on the Opto-μECoG array allows the possibility to achieve a truly untethered system. Maximized target cortical area available for optical stimulation: optically transparent indium tin oxide (ITO)  epidural electrodes of the Opto-μECoG array allow maximum exposure of the target cortical area for optical stimulation. Maximized spatial resolution of optical stimulation: the embedded light sources, placed on top of the ITO electrodes, were preciously arranged based on a recent study of the optimal spacing of subdural, epidural, and scalp … Continue reading
Unlike electrical stimulation, optogenetics allows neuronal manipulation with great cell-type specificity, with light directly affecting only those cells expressing opsins. In a recent report in Nature Communications, Krook-Magnuson et al harnessed this specificity to stop seizures in vivo in a mouse model of temporal lobe epilepsy. Mice were implanted with electrodes to record brain activity and 200µm thick optical fibers to deliver light to the brain. A closed-loop, on-demand responsive system detected seizures in real time, allowing temporal specificity, in addition to the cell-type specificity achieved through selective opsin expression. Specifically, the authors either selectively inhibited excitatory principal cells or, alternatively, excited a subpopulation of GABAergic inhibitory neurons in the hippocampus by delivering light at the time of a seizure. Both approaches proved successful, despite the less than 5% of illuminated neurons expressing opsins in the latter approach. Light arrested ongoing electrical seizure activity and reduced the incidence of events progressing to overt behavioral seizures.
Epilepsy, a condition of recurrent, spontaneous seizures, is a prevalent disorder, with 1 out of 26 people developing epilepsy during their lifetime. Unfortunately, for over 40% of patients, seizures cannot be controlled with current treatment options. Temporal lobe epilepsy, the most common form of epilepsy … Continue reading
As optogenetic neuronal control strategies develop and get widely adopted in neurobiology labs, the demand for devices allowing combined light delivery and electrophysiological recording is growing. These devices, commonly called opto-electrodes or optrodes, already exist under a wide variety of forms, from the simple home made single optical fiber + single electrode to more complex microfabricated multi-fiber/multi-electrode systems. In the past years, Zhang et al. integrated an optical fibre in a Utah Array, and NeuroNexus assembled an optical fiber on their standard silicon shaft. Other groups implemented waveguides directly into the optrode fabrication process: Cho et al. integrated a microstructured SU-8 waveguide on the shaft of a Michigan Probe and the group of Ed Boyden integrated 12 silicon oxynitride waveguides on silicon shafts (paper1, paper2). Royer et al. in the Buszaki lab managed to establish silicon based shaft arrays with integrated optical fibers.
In a recent paper published in “Lab on a Chip”, the Stieglitz and Lüthi labs introduced a novel optrode which also comprises a microfluidic channel for liquid delivery at the tip of the probe. This channel can be used for example to inject a solution containing a virus right under the waveguide tip and around the electrical … Continue reading
One of the primary goal of neuroscience research is to dissect the role of different cell-types in neuronal circuits. Thanks to the development of optogenetic reporters and control tools in recent years, researchers can now optically control and monitor the activity of genetically defined neuronal populations. Going deeper into the understanding of neuronal circuit requires to follow and control the activity of individual cells within these genetically-defined populations. Imaging the activity of individual neurons in vitro and in vivo can be achieved with classical microscopy techniques but labelling and following the activity of arbitrarily defined subsets of cells in a given population remains hard to implement. Optical highlighters which can be photoactivated or photoconverted are routinely used to label cell subpopulations but have only been used so far for anatomical tracing or cell migration studies. In a recent study published in JACS, Campbell and coworkers introduce a photoconvertible genetically-encoded calcium indicator, providing the possibility to easily monitor the activity of subsets of cells of a given cell type.
This dual-function Ca2+ indicator was made by combining two of the most powerful implementations of fluorescent protein (FP) technology: the “highlighters” that can be converted from non-fluorescent to fluorescent or from one … Continue reading
The ability to deliver light into the brain for the purpose of controlling neural activity or other biological processes, optogenetics, has opened up new frontiers in both basic neuroscience and neuroengineering. One arena of great activity is in the use of microbial opsins such as channelrhodopsins, halorhodopsins, and archaerhodopsins to make neurons activatable or silenceable by light, thus enabling assessment of the causal contribution of specific neurons, brain regions, and neural pathways to normal and abnormal behaviors and neural computations. To date, numerous in vivo studies have used optical fibers, and fiber-electrode hybrids, to deliver visible light into brain targets in which neurons express opsins, but an optical fiber can target just a single region. An implantable probe capable of delivering light to arbitrary points in a 3-dimensional volume would enable more versatile optical control, opening up the ability to deliver patterned light to manipulate neural activity in distributed brain circuits.
The Boyden lab recently developed a linear probe comprising a set of integrated microwaveguides running in parallel to each other, microfabricated on a single substrate and capable of delivering light independently to multiple brain targets along the probe axis. In a paper published in Optics Letters, they now extend … Continue reading
Numerous applications enabled by optogenetic tools require the delivery of different light profiles within tissue. In some instances, wide-field illumination is needed to blanket a region of a specific brain layer, while cell body-size beams are necessary in other cases to achieve highly-selective localized stimulation; in addition, spatiotemporal patterning or multi-level access of light may be incorporated. In a recent paper published in Biomedical Optics Express, Abaya, et al. presented a novel device structure that facilitates three-dimensional deep-tissue light penetration with capabilities for simultaneous spatiotemporal modulation with different wavelengths. This device consists of > 1 mm length needle-shaped waveguides that circumvent intrinsic tissue absorption and scattering. This array can be adapted to a wide variety of illumination systems (e.g., microscope, μLED arrays, optical fibers, collimated beams, spatial light modulators) and can potentially facilitate the advancement of a broad range of applications utilizing optical neural stimulation.
The waveguide array is micromachined from fused silica/quartz wafers, which are transparent to visible and near-infrared wavelengths. First, bevel blades are used with a dicing saw to create arrays of pyramids as tips for the array. Next, the shanks are formed by dicing down material in between the pyramids to produce waveguides having a pyramidal … Continue reading
There has been almost two decades of research in the field of genetically-encoded voltage indicators (GEVIs). Early probes carried channel-based voltage sensors (e.g. derived from potassium and sodium channels) but showed poor membrane localization. Membrane localization of GEVIs was greatly improved by replacing channel-based sensors with the voltage-sensing domain of Ciona intestinalis voltage-sensitive phosphatase (Ci-VSD). Despite this major improvement, the goal to record single action potentials and subthreshold electrical events in mammalian neurons with adequate temporal and spatial resolution still presents a challenge. The latest step toward this goal was taken by the Pieribone lab which came up with two Ci-VSD-based monochromatic GEVIs.
The first one, called ArcLight and published in Neuron, was obtained by combining the Ci-VSD and a super ecliptic pHluorin that carries a critical point mutation (A227D). Based on ArcLight, five probes were engineered with super ecliptic pHluorin A227D relocated closer to the S4 domain of the Ci-VSD, after amino acids Q239, M240, K241, A242, or S243. Out of these 5 variants, ArcLight A242 emerged as the best, exhibiting -35% change in ΔF/F in response to 100mV depolarizing steps in HEK293 cells and up to -5% change in ΔF/F for single action potentials in neurons. ArcLight A242 … Continue reading
In a recent paper published in PLoS One, Ohkura et al. introduce R-CaMP1.07, an improved variant of a recently developed red fluorescent Ca2+ indicator protein called R-GECO1. While the sensitivity of R-CaMP1.07 is similar to that of R-GECO1 (Kd for Ca2+ is around 200 nM), R-CaMP1.07 shows 1.5–2-fold greater signals than R-GECO1 due to its enhanced dynamic range (Fmax/Fmin is near 30). The greatest advantage of R-CaMP1.07 is that its excitation wavelength ranges from 500 to 580 nm, which rarely overlaps with the photo-stimulation range of channelrhodopsin-2 (ChR2). Taking this merit of R-CaMP1.07, the authors demonstrate an application example of this indicator in hippocampal pyramidal neurons expressing ChR2: the successful detection of Ca2+ signals in response to action potentials evoked by the photo-stimulation of ChR2. Needless to say, this red fluorescent R-CaMP1.07 can be used for Ca2+ imaging of cells expressing blue, cyan or green fluorescent proteins.